SpaceX iPhone 16 Pro Case with F9, FH, Dragon, and Starship

I don't have this phone. I used the model by Satyr ( https://www.printables.com/model/1003040-iphone-16-pro ) to align the buttons. If you want to change colors for the words and logos then change at 13 mm. The letters in "Space" are 1 mm taller than all the others. You can print all the other letters, swoosh of the X, and logos in one color, then change at 14.42mm and make "Space" another color. I added built in supports, so DO NOT enable supports in the slicer. For some reason after an update, I couldn't get PrusaSlicer to put in supports unless I painted them on. It was a real hassle, so I just added some. There is a .2mm gap between the top of the support walls and the start of the roof. They do a great job, so the first layer of the roof is pretty clean (see picture). They tear off very easily with pliers. Honestly, they use less material, are easier to remove, and do as good a job as slicer added supports. Also Available: ( https://www.thingiverse.com/mgranger114/collections/43893538/things ) --Imperial Cog 2 and 3 Card Holder --Rebel Symbol 2 and 3 Card Holder --SpaceX 2 and 3 Card Holder --Boeing PhantomWorks 2 and 3 Card Holder --All the above (except Boeing) for iPhone 12 Pro --All the above for iPhone 16 ProMax --All the above without a credit card holder