Spiral cone fidget toy popper

With the fidget cone, if you print them separately there can be some stringing between the sharp points. If you print them nested that helps a lot with the stringing and keeping the points tidy, but it can be very difficult to separate the two parts. This tool is handy if you have a lot of cones of the same size to separate. It's much faster and easier on the hands! The photo shows the cone popper and a cone printed at 50% size. How to use Put the freshly-printed cone into the hole point-first, and then put the smaller part into the hole afterwards, with the nub pointing down towards the base of the cone. Then squeeze the two parts together firmly, and the nub should push the inner cone out through the outer cone point without causing any damage. Have a glamorous assistant ready to catch the inner cone as it flies out at speed.