Spool Holder 130MM for 3KG rolls

I have some larger rolls that do not roll well on the bar. I wanted to be able to handle the PTFE tube as well so I expanded the current setup. I have printed with or without the supports. You may have some issues with the screws if you do not have a properly setup printer. Not to worry though you just need to make sure the screws are tight enough to not move. The 608 Bearings will handle the spinning. Parts needed: 1 - Base 2 - Rollers 4 - Pins Print settings: 20 % infill .20 Speed 4 walls Purchase 608 bearings. I used these because they were cheap. https://a.co/d/h2Pa3cJ