Stacked-Openable and Flat "Never Lost Clip" for IKEA Samla 5L/11L/22L

Two versions, both based on Canilupus original version that both share that I made the original model taller then cut the hinges to give the print-in-place hinges more clearance as the original model almost didn't break free for me. Both are 21mm tall, thus fitting all 3 small Samla sizes from both sides. The two versions are: Flat version: In case you need to slide your Samla into a shelf with very low clearance (not possible with original version). Note: These can only be stacked when used on the long side of Samla and then they are not openable if another Samla is stacked on top. If you don't have space-constraints, don't use this version unless you really dig the flat optics. Go with the original version or the hole-version: Hole-version: This is my main contribution: I added a tab with a hole which lets you open the clip even when other Samla containers are stacked on top of it easily. I use this all the time to lift a box that is on top and just throw in a screw driver or take one out, etc. I don't want to remove the box on top all the time. Both versions are fully printable without supports on the side. For installation use a thin piece of double sided tape to fixate it into the side of the SAMLA container (it will not hold by itself and has the clearance for the tape).