Star Wars Venisa Doza's X-Wing

This is a model of the X-Wing flown by Venisa Doza in Star Wars: Resistance. It has moving print-in-place wings. This ship is a modified T65 X-Wing. The cannons were replaced with two new cannons for the upper wings and missiles for the lower wings. The engines were also replaced with bigger models. The upper wings have cut-outs and the cockpit window is rounder. Dimensions length width height wings closed 45.6mm 42.2mm 8.3mm wings open 45.6mm 39.4mm 17.8mm The version with pin is compatible with a small pin and base (link) . Print Instructions I highly recommend you print the engines separately. If you print them attached to the wings, the nozzles will almost certainly break off. For separate engines and no pin , print: venisa doza-no engine.stl venisa doza-engine.stl For separate engines and pin , print: venisa doza-no engine pin.stl venisa doza-engine.stl (version shown in the photos) For attached engines and no pin , print: venisa doza-print.stl For attached engines and pin , print: venisa doza-pin.stl Printed at 0.15mm layer height. Requires supports on buildplate. The part doza-engine.stl was printed at reduced layer height and does not need supports. If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#