Steam Deck Clip On Stand Slim (Fit in Carry Case without remove)

I really like the original design, but I have to remove it before put my deck into the carry case which is a bit annoyed. So I refer to the original design and redesigned a carry case compatible version. You would need super glue instead of M3 thread in this design. 2023/5/7 update: After use it for a while, I found out it is too fragile. So I upload a stronger V2 version. I suggest you to print that version instead. Print settings You should print without support, your printer would bridge the gap. Suggest layer height: 0.2 mm