Super fast silica gel desiccant spool container - vase mode

About I really love original Silica gel spool container by @gdrag. However I wanted to achieve Three additional goals: Make a spiral (vase) print to reduce filament and time, Add some distance between side holes and internal wall of the spool to improve air circulation, Use cheap Chinese hygrometer/thermometer as a cap, so I can know more or less if I'm successful at drying filament. How to print: adjust bottom thickness to 1mm use spiral (vase) mode (optional for cap) I tried 0.25mm layer height (but think everything between 0.1 and 0.3 will work) The print works fine for 0.4 - 0.7 line width - for thicker lines - hole diameter can be to small and you can have some problems closing container with cap or hygrometer. Make a single test print before bigger batch. You can always try “XY compensation” (remember to compensate only container - not the cap) in slicer - but I'm not sure if it works in vase mode. Nevertheless up to 0.8 works for me - it's just very tight. Cura users: New Cura (5.2) removes all bottom holes by default in spiral mode - so after enabling “Spiralize” you have to uncheck “Remove All Holes” option to reenable holes on the bottom of the container. I used my Anycubic Mega (with changed printhead and Klipper firmware) and it prints in about 20 minutes (short version) TODOs: (done) Make various heights (done) Make lightweight cap in case One doesn't want to use hygrometer CHANGELOG: 13.07.2022. Redesigned container: 📷 Image redacted — claim this model to add your own media New project (but based on previous shape) Minor changes to help print better Two flavours: small_gap: holes on tom and bottom are narrower (1mm) and segments are 2mm thick big_gap: holes on tom and bottom are wider (1.4mm) and segments are 2.5mm thick Three sizes for each flavor (50mm, 70mm, 100mm) 12.04.2022. Redesigned container: 📷 Image redacted — claim this model to add your own media Added route for inserting hygrometer. Added curves to the design to reduce sharp corners and deceleration points. Now container can be printed below 15 minutes improved bottom grid pattern Added cap, so even if You don't have hygrometer, You can still use this design 11.04.2022. Initial design 📷 Image redacted — claim this model to add your own media