SV06 Heatbed Strain Relief - FOR NEW MODELS

I was able to print this on a Sovol SV06 with 15% infill, default walls, and .20mm layer height, PETG. Supports are most likely required. I used PrusaSlicer's organic supports. EDIT: Make sure you use loctite, lock washers, or locking nuts when you install the screws. A few months down the line, I noticed my screws started to get a little loose from the vibrations. An easy fix, sure, but it's annoying to have to peel up the magnetic sheet again. Don't make the same mistake I did!