T-Pull * Iron Sights * Rail Cover * Spring Spacer --> Blitzfire 2 * Dart Zone (Nitroshot)

Dart Zone Nitroshot Blitzfire2 Mods T-Pull + Printed Pin Rear Sight Insert for improved aiming Bottom Rail Cover for some additional color accent Spring Spacer (for the stock spring) All mods can be easily reversed if desired. Installation: Simply open the 3 screws on the slide, place the Rear Sight Insert into the recesses of the stock rear sight and screw the slide back together. The T-Pull simply attachs with the printed pin through the faux hammer. The pin may be a little difficult to insert because it fits quite tightly to press the T-pull onto the top slide so that it doesn't wobble later. Some 2mm crafting foam (or similar) to secure the Bottom Rail Cover to the rail. (put a strip of crafting foam between the rail and the Bottom Rail Cover to secure it like shown in the photos. A section of a halfed foam dart also works well for this.) -------------------------------------------------------------------------- The optional small spring spacer gives some extra FPS (approx. +5fps). Install it like shown in the picture. UPDATE 16.12.2025: Shortened the T-Pull by 5mm in length for optical reasons. Added a Drop In Rear Sight Insert for improved aiming. -------------------------------------------------------------------------------------------------------------- The files are already pre-oriented: My print settings for PLA: 0,2mm layer height 4-5 walls 7 top and bottom shell layers 20% gyroid infill (print with outer brim if you have poor bed adhesion) Thanks to Onino for the files I could use for this remix.