T-shirt & Desk Fan

I designed this housing for the Prusa radial fan to control the distribution of its airflow and enable it to be used as a portable fan. I added a clip so that I can carry it on my pocket and direct the airflow into my shirt. The clip can also be turned to allow desk use. This isn't the best solution yet, so a redesigned clip that can be used for both purposes will follow. Please notice, that all parts are held together by just one single M3 screw without a nut. I printet everything with PLA and 0.2 mm layer height. In addition I reduced the nozzle temperature to 195 degrees Celsius to avoid stringing at the front part. Disclaimer: The housing for the fan is the result of a DIY project that requires technical understanding and knowledge of electronics. The use and reproduction as well as any modifications are exclusively at your own risk. The creator of the files assumes no guarantee or liability. In particular, no liability is assumed for - the function, safety or suitability of the design - damage to persons, animals, objects or property - improper use or faulty reproduction - the use of unsuitable tools or components - the incorrect or improper use of electronics, tools or other components No instructions, recommendations or approval are given for the use or processing of electronic components. Electrical work may only be carried out by persons with the necessary specialist knowledge. By downloading or using the files and information provided, this exclusion of liability is expressly accepted.