TBS Mojito Lower Vertical Stabilizer (Motor Protector)

You'll need to likely cut off the existing nub, and sand the plastic to get this to glue down properly. I just scored the plastic with the tip of a razor blade and used hot glue, it's held up to a LOT of fast landings on gravel roads. Save your motor and propeller from getting nicked on landings. I recommend adding a nose skid so the plane lands level, only using this tail fin might cause the nose to dig in to the ground if you're not flared up enough. I sliced the front skid off an old Atomrc Dolphin to use on my Mojito.