Team Losi / TLR 22 1.0 and 2.0 12 mm Front Hex adapter

Front 12 mm Hex adapter for a variety of Team Losi 22 1.0 and 2.0 2WD buggies. Team Losi migrated to an in-hub bearing design with the introduction of the XX-Series of buggies. This hex was approximately 9.6 mm hex (~3/8") and was also employed on a variety of 4WD buggies for a time. This was carried into the 22 Series 1.0 and potentially a portion of the 2.0 buggies (not 100% on that). In 3.0, they moved to 12 mm hex completely (along with almost all other modern buggies). This adapter is intended to slip over the existing 9.6 mm hex, and match up with a 12 mm hex on the rim. It should fit relatively tight to the wheel and effectively take up the gap between the old drive spindle and the modern rim. There are a variety of thickness posted (0.4, 0.6, 1, 1.6, and 2 mm). You may/may not need a spacer to help support the axle/screw so a 2 mm thick spacer has been included. This will be highly dependent on the rim (may need to adjust the outer diameter/depth for best fit). Light reaming/filing may be needed at the hole otherwise no prep should be needed after printing. NOTE: I have not printed this and do not have a 1.0 or 2.0 22 to test this on, but this was requested by a user.