Towel- or cellphone holder/hook with wallmount

I needed a new towel hook when my toilet roll holder broke down - for consistency's sake. I also needed to hide all the holes drilled in the wall by the previous owner. The result became a cellphone holder as well as a towel hook. Thickness: 1 cm / width: 5 cm / depth: 7 cm / height: 8,5 cm Tolerances for dovetail joint: 0.2mm. The screw holes of the wall mount are 2 cm's appart, measured from each hole's center point. The mount works with a dovetail joint. No glew or screws needed except to fix the mount to the wall. The two parts fit snuggly together - you should be able to, with a little bit of wiggling in the beginning, slide the hook over the mount without much issue depening on the tolerances of your printer. I look forward to seeing your makes :)