TPU gasket for X1C/P1S/P1P top plate REMIX

I printed this in 95a TPU with a 15% concentric infill. I used a .4mm nozzle with a .16 layer height using the “Generic TPU” preset in Bambu Slicer. I'm sure a .2mm nozzle with even a finer layer height would look a lot better as well. I used standard supports everywhere. I also printed this on the Bambu Lab High-Temperature plate. (not recommended without applying glue or some kind of separator before) I was testing out the fitment and have not glued it down to the printer yet. I'm deciding to print this in a black 95a TPU then deciding to glue down. *From the prints that I've ran after including the gasket under the lid* The vibration of the lid was way quieter especially when the printer was performing the input shaping calibration.