TS21 holder for IKEA Skadis (T-Clip System)

A basic Miniware TS21 soldering iron holder for IKEA Skadis. Bit on the loose side so that if you install the finger grip, it still fits. It uses the T-Clip locating pin variant, so it shouldn't rotate. Should be used with low profile clips. I printed in 0.20mm PETG, others should work too. Print upright with no supports. To install it, first put the T-clip through the clip seat on the model, then put the other side of the T-clip through the hole on your Skadis. Finally, align the part and tighten the T-Clip.