TTArtisan 35mm F/1.4 Rugged Box

Everything is printable without supports. Print the Seal out of TPU. You will need 3x M3x35mm screws for the hinge and latches. If you are experiencing too tight of a fit when closing the box, try scaling down the seal in the Z direction to maybe 1.2mm or just use the box without the seal installed. Thanks to @Whity for the parametric design of the rugged box I used and @Yanev for laying the groundwork before him. I recommend printing the box, lid and latch with “Fuzzy Skin” applied only to contours, I use 0.3mm point distance and 0.1mm thickness.