(UPDATED) Ender 3 V3 SE Vent Ring

(UPDATED) 12/19/23 Re-made the ring from scratch. 1 - Fixed the gap issue between the fan and ring. 2 - Now has 3 more vents than the original. Much less back flow through the fan now (still a small amount, but no where near like before). 3 - Vents now push air straight out and down. 4 - Increased the overall volume inside the model. This is a now re-imagined Vent ring from _3DDP_ that fits an Ender 3 V3 SE. Must be paired with Sand's lightweight fan shroud found on Printables. https://www.printables.com/model/637754-ender-3-v3-se-lightweight-fan-shroud May also work with Muganon's Fan shroud. UNTESTED Print settings: Nozzle diameter: 0.4 mm Layer height: 0.2 mm Infill density: 100% Supports: None Material: PETG DISCLAIMER: I am by no means an engineer, just a hobbyist that loves tinkering :) PS: Don't mind the gray PLA print. It printed at max speed and a not perfected z-offset, it did some weird things, it's mainly to help show the details better :)