Upward Bulb - For Seeds

3/8/2026 Upward Bulb - For Seeds: This is a "remake" of the "Upward Bulb - Improved!." Is the same model but has seed holes. It is made for the smaller three wire white epoxy seeds. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5". If you have "larger" seeds, you might still be able to use this prop! Just have the pixels face off the back of the prop. There has been limited testing for this, but I believe it will work! It is composed of 27 separate pieces. (there are 2 test pieces used to test print and don't attach to the bulb). Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high. The pieces that model the male end of the bulb are 10mm thick without raised edges. I hope this gives this area a different look. The male end pieces are attached with a "hidden" circular dove tail. Its approximate size is 538mm wide x 1043mm high (21.5in x 41.75in). It holds 222 seed pixels. Printer: Nothing new here. All the parts should be able to be printed on a minimum bed size of 220x220mm. Assembly: Please use the two Assembly pictures to see how to put it together. The picture with "Assembly" in the name shows how the pieces fit together. Thank you for looking at or even attempting to print this. I would be interested in any feedback. I'll correct any mistakes as quickly as possible. Enjoy. *** Updates ***