V Multiboard Hex Key holder

A compact and pleasing looking Multiboard Hex Key holder. The holes are set for 8, 6, 5, 4, 3, 2.5, 2, and 1.5 mm keys. This is a mix built on Multiboard's midweight snap part that was released for remixing. I add also the FSCad file which can be easily changed as needed for your setup. Theoretically, you can take the entire thing on and off the board, but I'm not sure if this would last over time. On my printer (Creality CR-10 SE) I didn't need support, printing it with the large surface on the print bed (snap pointing up). Print config was the regular Multiboard's recommendation (3 layers for walls, 15% fill).