Wipes Dispenser

WHIPE DISPENSER First of all, this is a deep remix of Honza “ Condom dispenser” , which used rubber bands for his design, which I loved the idea of. So go visit his profile to see his other designs. Honza | Printables.com Materials you will need 2 Rubber band of Ø56mm OR 4 Rubber band of Ø22mm Alcohol Wipes with an approximate measurement of 57mm of length and 53mm of width (See picture below) Print Orientation and Notes 📷 Image redacted — claim this model to add your own media 📷 Image redacted — claim this model to add your own media 1-Main Body , support will only be needed in the middle of the entrance of the wipes. Layer height: 0.3mm Perimeters: 3 Infill density: 15% Fill pattern: Cubic 📷 Image redacted — claim this model to add your own media 2-Riser Layer height: 0.2mm Perimeters: 3 Infill density: 15% Fill pattern: Cubic 📷 Image redacted — claim this model to add your own media 3-Hook Layer height: 0.2mm Perimeters: 3 Infill density: 15% Fill pattern: Cubic 📷 Image redacted — claim this model to add your own media 4-Press-Fit Screw Layer height: 0.2mm Perimeters: 3 Infill density: 15% Fill pattern: Cubic Need to print 4 of them For material, PLA or PETG works great with this design. Assembly 📷 Image redacted — claim this model to add your own media 📷 Image redacted — claim this model to add your own media Section View You will need some patience for this step. If you are going to used 2 large rubber bands, you should fold it in 2 and place it as shown in the figure on the right. (This is more difficult) If you are going to use 4 small rubberbands, you should put them double in each length to have greater strength. It is extremely important that the elastic bands are inside the channel of the 2-Riser. The photo below shows how it should look. if this is not done, the mechanism may get stuck or jam. 📷 Image redacted — claim this model to add your own media Happy Printing :)