WLED case for Flip_C3 board and wago connectors

I designed this for a WLED project to control my Govee permanent lights with a Flip_C3 board (which can run off of 36V that the Govee lights need). This has a built-in custom mount for a Flip_C3 board, mounted inside a project box that also houses Wago connectors for the ground/35V/signal wires. Built-in cable ramps for incoming power and outgoing power/signal cables; I reused the ones from my original Govee connector, just shortened them, stripped, tinned, and connected to the Wagos. Tighten them down onto the ramps with small zip ties for strain relief. I used the push-in connectors on the Flip_C3 for the power and ground, and soldered a LED signal wire to the Flip_C3, which goes into the 2-lever Wago. Hardware needed: 1x Flip_C3 board, designed by clomads ; see https://wiki.vdbx.io/product/flip_c3 for details. Can be purchased from amazon or tindie . 4x M3 heatset inserts 4x M3 x 20mm bolts 2x M3 x 8mm bolts (self tapping) 2x Wago 221 series 3-lever for power connections 1x Wago 221 series 2-lever for LED signal 2x zip ties for strain relief