Xacto minicutter - safety clip

Immediately after printing this awesome little knife I stabbed myself in the thumb (like an idiot). This clip stops that happening and its a really loose easy to remove fit (with a nail slot to remove it) that doesn't add to the profile of the knife! Rattles a little as its so loose but doesn't come out with vigorous upside down shaking. Deliberately 3mm shorter than the slot for ease of removal/refitting. Designed in Tinkercad by cutting the original body out of a block then adjusting the length and trimmed most of the side grooves until it would fit inside freely. Then adding a thumbnail slot at either end.