Yamaha MT-07 / FZ-07 / XSR700 / Tracer 7 – Front Stunt Pegs / Axle Sliders (M8-M10, Smooth)

3D printable front stunt pegs / axle sliders designed for the Yamaha MT-07 / FZ-07 platform. Protects the front axle in case of a crash or drop. Threading: M8 – the axle hole may need to be drilled out to fit. M10 – the axle hole needs to be drilled out to fit. Surface: Smooth finish. Confirmed compatible (front): 2021–2026: MT-07, MT-07 35KW, MT-07 Pure, MT-07 Pure 35KW, MT07, MT07 CA, XSR700, XSR700 CA, XSR700 Legacy, Tracer 7, Tracer 7 35KW, Tracer 7 GT, Tracer 7 GT 35KW Likely compatible – not 100% confirmed (front): 2021: Tracer 7, Tracer 7 35KW, XSR700, XSR700 CA 2020: MT-07 ABS, MT07, MT07 CA, Tracer 700, XSR700, XSR700 CA 2019: MT-07 ABS, MT07, MT07 CA, Tracer 700, XSR700, XSR700 CA 2018: MT-07 ABS, MT07, MT07 CA, Tracer 700, XSR700, XSR700 CA 2017: FZ07, FZ07 ABS, FZ07 ABS CA, FZ07 CA, Tracer 700, XSR700 2016: FZ07, FZ07 CA, Tracer 700, XSR700 2015: FZ07, FZ07 CA, FZ07 VA, MT-07 ABS Hardware needed: M8 stainless steel (A2) threaded rod M8 stainless steel hex nuts or M10 stainless steel (A2) threaded rod M10 stainless steel hex nuts Also available: M8 / M10 version, smooth / knurled variant, front / rear pegs. M8 vs M10: Originally I designed the sliders for an M10 rod. Drilling the axles out to 9.5mm was pretty easy but getting it to 10mm was a pain. I would choose M8 over M10 if I had to drill the axles out again. My Print Settings Printer: Bambu Lab A1 Material: PETG Infill: 50% (Gyroid or Cubic pattern) Layer Height: 0.16mm High Quality Wall perimeters: 6 Top/Bottom layers: 6-8 ATTENTION!!!: remember to put in a print pause once the coutout for the hex nut is printed. Then insert the hex nut and continue printing. PSA: These parts have not yet been tested on a real bike. Use at your own risk. I will update this listing if testing results become available.