Zipper Pull

I combined a grip from one of my previous designs with a hook at the end to act as an aid for using a zipper. The grip was about 5 inches by 4 inches, estimated by the size of a hand. It was about an inch tall and rounded. Cylinders were cut out to form the grooves of each finger. There is a rounded portion added onto the grip to extend it into the palm of the hand based on size. I also attached a hexagon shape to the bottom where the hook would come off. Its measurements aligned with the height of the grip, but were fit to size based on personal desire and aesthetics. I attached a one-inch hook shape that would come off the grip to fit inside a zipper. The diameter of the hook can be altered to fit the size of the hole in the zipper being used. I then added a pointed end to make it easier to thread into the zipper.